Mechanical forces play increasingly recognized roles in T cell receptor (TCR) signal transduction. Hu and Butte (2016. J. Cell Biol. http://dx.doi.org/10.1083/jcb.201511053) demonstrate that actin is required for T cells to generate forces at the TCR and that exogenous application of force can emulate these cytoskeletal forces and trigger T cell activation.
Physiological T cell stimulation requires a specific peptide–major histocompatability complex (pMHC) interaction and an intact F-actin cytoskeleton, and is further enhanced by myosin II–based contractility (Valitutti et al., 1995; Ilani et al., 2009). This concept of chemical specificity enhanced by force sensing has captured the imagination of investigators from fields of immunology, engineering, physics, and cell biology, but experimentally testing this concept is challenging. In this issue, Hu and Butte show that they can replace the role of F-actin in T cell triggering with forces delivered by an atomic force microscope (AFM). Several studies over the past decade converge on the idea that T cell recognition is based at least in part on mechanotransduction, the conversion of a force into a biochemical signal (Vogel and Sheetz, 2009), pointing to an important role for physical forces in T cell responses. Hu and Butte (2016) demonstrate force-based T cell receptor (TCR) triggering in a system with a crippled F-actin cytoskeleton. This system constrains potential mechanisms through which forces can be linked to signaling events and thus these findings offer an exciting advance.
TCR signaling has been traditionally studied using bivalent anti-CD3ε antibodies that bind the CD3ε signaling subunits of the TCR and activate TCR signaling pathways by artificially aggregating the receptors in the membrane. This artificial method of initiating TCR transduction made studying the TCR response to force a challenge and seemingly argued against the idea that T cells need to apply a force to the TCR to trigger a signal. However, the physiological ligand of the TCR is a monomeric pMHC on the surface of antigen presenting cell, which creates an opening for force in extending the sensitivity, and perhaps also the specificity of the TCR. It is clear that monovalent pMHC binding to CD4+ T cells does not trigger signaling despite the potential of CD4 to recruit the kinase Lck to the TCR. Thus, experimental efforts to study force-actuated signaling in T cells must establish initial conditions to engage the TCR without triggering signaling in the absence of an applied force. Such conditions have been achieved, demonstrating force-actuated TCR signaling in multiple configurations (Kim et al., 2009; Li et al., 2010; Liu et al., 2014). However, how an applied force converts nonproductive TCR engagement into a productive one and whether this is a fundamental mechanism of natural pMHC recognition by T cells in vivo remain unresolved. This is the context in which Hu and Butte (2016) explored TCR responses with an AFM to address the linked questions of how triggered T cells generate force and if force can actuate TCR signaling.
In their study, Hu and Butte (2016) coupled anti-CD3ε antibodies or pMHC complexes to an AFM tip and used a specially designed AFM to both measure forces on the T cell and to apply complex patterns of force onto the T cell. The AFM tip was a single silicon crystal 4–6 µm high and with a ∼6-nm radius of contact (Fig. 1 A). Although the coating density is not explicitly determined, the coupling chemistry used should be able to achieve high-density, close packing of the anti-CD3ε antibodies or pMHC (Fig. 1 B). Thus, the ligand presentation by this device is likely to be similar to earlier studies where MHC monomers were closely packed onto quantum dots, which were highly effective at T cell activation (Anikeeva et al., 2006). Hu and Butte (2016) showed that contact with the anti-CD3ε– or pMHC-coated AFM tip induced similar Ca2+ signaling in T cells, which in turn generated pushing and pulling forces on the AFM, consistent with previous results (Husson et al., 2011; Bashour et al., 2014). Treatment of the cells with latrunculin A, which sequesters G-actin and prevents its polymerization to F-actin, prevented Ca2+ flux and force generation, illustrating the importance of the cytoskeleton in TCR triggering. In this context, Hu and Butte (2016) discovered that applying an oscillating force to the anti-CD3ε–coated AFP tip in contact with the latrunculin A–treated T cell surface restored Ca2+ signaling. Control antibodies coated on the AFM tip in contact with T cells didn’t induce a Ca2+ flux, demonstrating that specificity was preserved. It remains to be determined if similar effects can be seen with pMHC, which appeared to be less able to sustain high pulling forces.
The use of AFM presented by Hu and Butte (2016) builds on a series of studies demonstrating force actuation of TCR-mediated signals. These earlier studies used different strategies to achieve 0-force baselines without signaling and then activated signaling by applying a force (summarized in Fig. 1). Kim et al. (2009) generated an anti-CD3εγ–specific antibody that bound to only one site per TCR complex, such that it was unable to cross-link the TCR and trigger signals even when coated on 1-µm-diameter beads. When the cell-attached anti-CD3εγ beads were subjected to tangential forces on the order of 1 nN with an optical trap (Fig. 1 C), the TCR was triggered as indicated by a cytoplasmic Ca2+ increase. It was particularly important in this study that the force was applied tangentially and not vertically and this was explained in terms of the forces T cells would naturally generate during migration over the surface of an antigen-presenting cell. The coating of that anti-CD3εγ on the 1-µm bead likely generates a large surface area for the application of force (Fig. 1 D). Tangential movement might also “roll” the bead over the surface, generating a mixture of stretching and compressive forces, which would not be generated by vertical pulling. Subsequently, Li et al. (2010) used a set of recombinant anti-CD3ε–based single-chain Fv antibody domains that were presented on the surface of cells with long, flexible stalks composed of proteins such as the sialomucin CD43 (Fig. 1, E and F). T cells that came into contact with cells expressing the extended anti-CD3ε constructs were not activated. Similar constructs were reported to be unable to trigger T cell activation, but this was attributed to their failure to form close cell–cell contacts from which the large tyrosine phosphatase CD45 could be excluded (Chang et al., 2016). However, Li et al. (2010) could activate signaling by providing tangential shear forces with a micropipette. This result thus reinforced the work from Kim et al. (2009) that TCR signaling from suboptimal anti-CD3–based stimuli could be rescued by the application of large physical forces in a manner that would generate a mix of pulling, pushing, and sliding forces. The orientation of an AFM tip is comparatively fixed relative to the cell; therefore, Hu and Butte (2016) avoid the issue of rolling behavior and could better isolate the effect of vertical forces; their findings strengthen the earlier studies of Kim et al. (2009) and Li et al. (2010). The AFM approach also provides better control of applied forces than the cellular-level application of shear and avoids artifacts associated with optic trap illumination.
In a different approach, Liu et al. (2014) used a biomolecular force probe (BFP) both to interrogate the response of single TCR–pMHC interactions to force and to test the ability of serial, single interactions to be summed by the T cell to generate a robust Ca2+ response. In the BFP experiment, a low density of agonist pMHC is attached to a 1-µm bead, which was then docked on a red blood cell (RBC) held in a suction pipette (Fig. 1, G and H). RBCs were used in this study because their physical properties are uniform and well understood, which is an advantage over AFM technology. In the absence of cell contact, the bead attached at the apex of the RBC is imaged with nanometer resolution and high speed as it oscillates based on the thermally driven fluctuations in the RBC membrane. A T cell bearing the appropriate TCR is maneuvered into contact with the bead and when an interaction takes place, the linkage to the T cell dampens the oscillation of the bead to allow detection of the bond lifetime, its response to applied force, and eventual rupture. An exciting analytical finding from these studies was that the agonist pMHC forms “catch-bonds” with TCRs, such that the bond lifetime is actually increased as force is applied in the 10-pN range. Liu et al. (2014) then observed cytoplasmic Ca2+ elevation during repeated trials when T cells accumulated a series of single TCR–pMHC catch bonds totaling 10 s within a 60-s period. The identification of 10 pN as a critical threshold has been reinforced by recent studies with DNA-based force sensors and tension gauges (Liu et al., 2016). Hu and Butte (2016) explored this reinforcing behavior in more detail, applying periodic inputs to the T cell and in a configuration that is more accessible than BFP.
In all of these previous studies, the mechanosensing activity of the TCR is always taking place in a cell with an intact actin cytoskeleton to help interpret the external force. In this setting, there are many paradigms for mechanotransduction that might apply to the TCR and many possibilities to test. Hu and Butte (2016) were able to complement a pharmacologically induced cytoskeletal defect by applying an oscillating force to the TCR. Interestingly, they were not able to detect evidence for the accumulation of discontinuous signals, suggesting that this type of signal accumulation may require an intact F-actin cytoskeleton. Regardless, the success of applying oscillatory force to rescue TCR signaling in a system depleted of F-actin suggests that the necessary force sensing may very well be encoded in TCR proximal elements, if not being intrinsic to the TCR complex itself. AFM-based assays for F-actin–independent force sensing by the TCR should now enable the systematic testing of such hypotheses about the TCR by also taking advantage of classical models of early TCR signaling. Beyond forces generated by the T cell, this study further supports the idea that forces generated by the antigen presenting cell may influence T cell activation. A fuller story of the role of forces in immune cell function is thus developing, with complementary studies showing that dendritic cells modulate the mobility of ICAM-1, which in turn affects T cell activation and function (Comrie et al., 2015). Finally, the approach of Hu and Butte (2016) is part of a new generation of AFM-based methods, including the stiffness clamp method developed by Webster et al. (2011) that provide new levels of control over the presentation and response of biomolecular cues.
The authors declare no competing financial interests.
- Submitted: 19 May 2016
- Accepted: 19 May 2016
This article is distributed under the terms of an Attribution–Noncommercial–Share Alike–No Mirror Sites license for the first six months after the publication date (see http://www.rupress.org/terms). After six months it is available under a Creative Commons License (Attribution–Noncommercial–Share Alike 3.0 Unported license, as described at http://creativecommons.org/licenses/by-nc-sa/3.0/).